General InformationHigh efficiency and reliabilityRemote On/Off function100% Hi-pot, ATE, and burn-in testedRe-settable power shut downNoise Killer (Thermal fan speed control function)Low noise and rippleTechnical InformationSpecification Compliance: ATX12VNumber of Fans: 1Protection Type: Short CircuitProtection Type: Over CurrentProtection Type: Over VoltageReliabilityMTBF: 100000 HourPower DescriptionInput Voltage: 132 V ACInput Voltage: 264 V ACInput Voltage Range: 100 V AC to 132 V ACInput Voltage Range: 200 V AC to 264 V ACOutput Voltage: 3.3 V DCOutput Voltage: 5 V DCOutput Voltage: 12 V DCOutput Voltage: -12 V DCInput Current: 8.50 A @ 110VInput Current: 5 A @ 220VOutput Power: 400 WInterfaces/PortsReceptacles: 1 x 24-pin ATX MotherboardReceptacles: 1 x 4-pin ATX12V MotherboardReceptacles: 5 x 4-pin LP4 Peripheral DeviceReceptacles: 1 x Serial ATAReceptacles: 1 x 4-pin SP4 Floppy DriveReceptacles: 1 x PCI-EPhysical CharacteristicsHeight: 3.4"Width: 6"Depth: 5.5"MiscellaneousAdditional Information: Switching Power SupplyCertifications & Standards: FCC part 15 subpart J Class BCISPR 22 Class BUL 60950IEC 60950TUV EN60950NEMKO (CB Report)WarrantyLimited Warranty: 1 Year

Input Range - 100 to 132Vrms or 200 to 264Vrms, Manual selection Frequency - 47 to 63Hz Input Current - 8.5A (RMS) 115Vrms/60Hz, 5A (RMS) 230Vrms/50Hz Inrush Current - 100A Max cold start, 120A Max warm start measured at 264Vrms/50Hz Dielectric Withstand - Input to frame ground 1800V AC for 1 second Efficiency - 70percent minimum measured at nominal AC main voltage and frequency with maximum loads on all outputs Rise Time - Less than 20ms on all outputs Hold-up Time - 17ms minimum at nominal input voltage Power Good Signal - Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible) Leakage Current - Not exceed 3.5mA MTBF - 100,000 hours on maximum load at 25 C Dimension (WxHxL) - 150x86x140mm / 6x3.4x5.5inches - Complied with ATX12V 2.0 standard - High efficiency and reliability - Remote On/Off function - Noise Killer (Thermal fan speed control function) - Low noise and ripple - Complies with FCC part 15 subpart J Class B and CISPR 22 Class B - Output over voltage, short circuit, and over current protection - 100% Hi-pot, ATE, and burn-in tested